0
The Cam sensor is located on the passenger side of the engine compartment below the alternator (not directly below, but that is the general area. You need a mirror to see it, or you can find it by simply feeling around. It is very easily replaced. Good luck
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Should you have the cam angle recall done on your 2000 F-250 Diesel?
Yes it replaces the old cam sensor (black with gold bracket) with new cam sensor (gray with silver bracket), it does not have any thing to do with any cam angle.
How old is cam cam from 8 flavahz?
Cam cam is 13
How do you change the fuel level sensor in a 2000 Impala?
To change the fuel level sensor in a 2000 Chevy Impala, first close the gas and power lines. Remove the wiring and then drop the car tank. Remove the old fuel level sensor and replace it with the new one.
How do you replace oil sensor on 2000 dodge ram van?
Unscrew the old one and screw the new one in.
How old is Cam Bedrosian?
As of the 2014 MLB season, Cam Bedrosian is 22 years old.
How to change cam sensor 3.5 l dodge 300m?
Loosen the bolts that are holding down the plastic intake manifold. The cam sensor is located on the right side front of the head as you are standing at the front of the car. Remove the bolt holding the old sensor and remove. Pull the red plastic piece out of the wiring connector, disconnect the plug. Replace with the new sensor and tighten all the bolts you loosened and replace the plug. Do not remove the paper that is on the end of the new sensor, it is a spacer and will be removed when the car is started.
Where is cam shaft sensor located 1993 Chevy 350 5.7?
A 93 does not have a cam sensor. Everthing is in the distributor like the old stuff was. If the engine has no spark then the ignition module are the pick-up coil in the distributor is bad. I would also check the coil and coil wire. If this don't help you, then ask your question again with your synptoms. GOOD LUCK
Whee is the cam sensor located on a 7.3 L 01 F250?
the cam shaft sensor is down by the crank shaft pully and when you are facing the motor it is on the left side of it it has a siliver bracket and takes a 10 mm socket and a extension dont pull off the belt you can work around it THE OLD SENSORS THAT ARE UNDER RECALL IS BLACK WITH GOLD BRACKET
How old is Sandra Cam?
Sandra Cam is 39 years old (birthdate: June 30, 1972).
How old is Cam Clarke?
Cam Clarke is 54 years old (birthdate: November 6, 1957).
How do you replace an o2 sensor on a 2000 s10?
Unplug and remove the old one. Screw in the new one and plug in the wires.
How do you change the crankshaft position sensor on a 2000 Dodge Neon?
Take off the old one and put the new one on.
