Very common for these to go out. Remove the battery. Look on the driver's side of the cyl. head and you will see a square sensor. Un-clip it from the harness and take out the four bolts (10mm). Replace. 20 minute job.
Not sure what align means, they only bolt on one way.
Its below the CAM SENSOR.. while facing the front of your engine it is located on the Right side of the engine the Cam Sensor has a shap of a square and the screws are in each corner the oil sensor is below it...
no cam sensor signal to pcm with crank sensor signal present. check for 5 volt ref and ground at cam sensor connector. scope cam signal. most likely cam sensor defective, hall effect type sensor
It tells the computer the rotational position of the camshaft.
on the drivers side of the motor, top, front of cam sensor
Driver side end of the cylinder head.
2006 was the last Neon. The cam sensor was located on the driver side end of the cylinder head.
The cam sensor is on the driver side of the cylinder head.
on the driver side of the engine right below the cam sensor on the head.
I could be wrong but look for a cam sensor shaped thing at the back of the cylinder head (left side relative to car).
Yes
Crank and cam sensors, yes. Vehicle speed sensor, no.