from under the truck look up at the front of the motor and it is right there above the harmonic balance. It is one two wire plug and a 10 mm bolt holds it in
The position of the camshaft sensor on your 1997 Camaro is dependent upon the type of engine in the Camaro. In most cases the camshaft position sensor is on the back of the left-hand cylinder head.
its located in the distributor at the back of the motor.
Where is the camshaft sensor located in 1997 Chevy venture
Undecided QuestionShow me another » Where is the camshaft position sensor located on a 1997 pontiac with a 3800 motor
On the 97 s series trucks with the hvs, The camshaft sensor is located inside of the distributor.
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt
the sensor is located behind the pulley for the water pump has one single 8mm bolt in it u need to remove pulley to get at it
1997 Dodge diesels come with the 12 valve cummins engine. It is fully mechanical and does not have a camshaft position sensor. "Dodge cummins diesel forum" is a good resource for dodge cummins owners.
Inside the timing chain cover there is a crank position sprocket and a sensor that connects into the side of the timing chain cover. There is also a sensor in the distributor(this is the camshaft position sensor). The connector faces the firewall. To setup your timing you have to rotate the distributor to 0 deg or you will get a P1345 code. A timing light won't help. If you don't have the right equipment you need to take it to the dealer or keep adjusting the distributor until the code goes away. Jon
If I'm not mistaken, I think the camshaft position sensor on these engines is built into the distributor. You'd have to replace the whole thing.
Rear camshaft seal bad. Replace. located behind cam sensor.