you can't fix a sensor, you can replace one by removing it and installing the new one...:)
Yes it does have ABS. The older Protege 1997 and older dosnt.
Begin by removing the rear engine cover from your 1997 Land Rover Discovery. Remove the crankshaft sensor wiring harness. Remove the crankshaft sensor retaining bolts. Reverse the process to install your new crankshaft sensor.
does a 1997 1.5l maxda protege have a timing belt or timing chain. When should i change it.
location of crankshaft sensor on 1997 Infinity I30 is it on the engine or in the gas tank plz show a pic
need more info my friend
It is the center to the right of the engine...
right side of crankshaft pulley
It does not have a crank shaft sensor.
It means there is bad/no connection between the car's computer and the oxygen sensor after the catalytic converter.
Center of the dash board you moron.
Should be the tensioner that the Alternator belt goes to
the crankshaft sensor is located behind the harmonic balancer on the ft timing cover
The timing sensor is called a Crankshaft Position Sensor (CKP). It is located at the 10 O'Clock positon on the crankshaft pulley.
The 1997 Chevy Malibu crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
Above the brake pedal,its black plastic.
the part of the transmission where the fluid goes is on the drivers side part of the transmission. its right above the transmission temperature sensor and its the biggest bolt head right above the transmission temp sensor
Check the Crankshaft position sensor
on the right side of the engine
The crankshaft position sensor is at the rear of the engine where it joins with the transmission bellhousing. It is at the left (front) side, not far from the starter.
need to replace the intake manifold gasket