answersLogoWhite

0


Best Answer

Where is the camshaft position sensor located on a 2003 Nissan Sentra GXE?

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the camshaft position sensor located on a 2003 Nissan Sentra GXE?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the camshaft position sensor on a 1996 Nissan Sentra?

in the distributor, you have to replace the whole unit.


Were is the crank position sensor on a 1999 Nissan Sentra?

I can not find where is located the position of sensor crank of 1999 nissan sentra 2.0 ( in what point is located in the motor)


Where is a 2004 Nissan Sentra fuel filter located?

what is the proper position of ignition coil for 2004 Nissan sentra 1.8s?


Where is the camshaft position sensor on a 2004 Nissan Sentra?

One of the sensors is located on top of the motor by the passenger side it looks too small but is one part inside the motor.


Camshaft position for a 1.8L Nissan Sentra?

I'm removing the head on my 2001 Nissan Sentra DOHC 1.8L, I noticed one of the cams has raised notches on it. Do these indicate the stage and if so is TDC when the single notch is under the sensor?


Pcv valve Nissan Sentra 2003 where is it located?

where is the pcv valve located on a 2003 Nissan sentra


Where is the PCV valve located for a 2002 Nissan Sentra?

where is PVC valve located on 2002 Nissan sentra


Where is the crank sensor on a 2000 Nissan Sentra?

where is the crank sensor located on 2000 nissan sentra


Where is the crank position sensor located on the Nissan sentra GXE 1.6 L engine?

For the 1.6 engine, Its in the distributor.


Where is the fuel filter located on a 2002 Nissan Sentra?

problem with fuel filterhow do i change the fuel filter on my 2001 Nissan sentra gxe, and where is it located?


Where is the fuel pump relay located on a 1996 Nissan Sentra?

feul pump relay on a nissan sentra 1996


Where are the ignition timing marks on the block of a 1989 Nissan Sentra?

on the camshaft pulley there are six notches located on the inside lip closest to the block. there is a 2in pin at the 1 o'clock position when viewed from the front. each notch is a certain degree I have yet to verify.