Where is the camshaft/ crank position sensor:
Under the engine, driver side, just above the exhaust which has three 1/2 bolts, there is a grey (covered in oil) circular cap with two 8mm bolts and a six inch wire going up toward the back of he engine. After you remove this cap the sensor is there held in with two 7mm bolts and two spacers, the six inch wire has a clip which you will have to remove. I suggest doing this after you have remove the two 7mm bolt holding it in, this way you can use a slotted screwdriver to release the clip while you hold the sensor with your other hand.
To replace do everything in reverse. Getting the clip off and on are the hardest parts, very little space.
Note:
Do not over tighten the 7mm bolts when you replace! this may break your new sensor.
Good Luck
In order to replace the camshaft position sensor, you would need to disconnect the electrical plug holding it in. Using a socket, hold down the bolt and remove the camshaft position sensor.
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
How do u replace the camshaft sensor for a 2000 Nissan xterra 3.3L and where is its locatoin
Replace the crankshaft and camshaft senors and then clear the codes with an oBD II engine scanner and that will fix it.
I changed only the camshaft position sensor on my 2000 Kia Sportage. So I don't think so.
how to remplace position of oxigen sensor
do you need to take off the timing belt to replace a camshaft position sensor on a 2006 kia sorento
Remove engine cover. Remove plastic cover over injectors. Camshaft sensor is in front of the oil filler cap, 3 wire black connector. It's held in by one E-Torx bolt. Remove the bolt and connector and it pulls straight up.
Show me how to replace the camshaft position sensor on a 2000 volkswagen new beetle
camshaft location on a 06 xterra bank 2
the camshaft position sensor is on the left side of the engine , at back on the upper side . you have to demont the conector , than unscrew and replace it