Want this question answered?
Exhaust camshaft sensor signal and the intake camshaft sensor signal. Happened to my BMW few days ago.
The 1996 BMW 328 camshaft position sensor is located on the front of the cylinder head. The camshaft position sensor should be labeled as such.
Remove oil filter cap. Using your torcT30 bit and Allen 5ml loosen back shaft to expose sensor. Remove and replace sensor , reverse install camshaft.
http://forums.bimmerforums.com/forum/showthread.php?t=886595
All depending on the year of your vehicle will determine the location of the camshaft position. The camshaft position sensor, or cps, is located just under the head gasket. They are two different sensors, so be sure to deal with the correct one.
The sensor is located at the front of the engine near the oil filter housing. To the left of the housing. 2.5 Z3
small sensor on front of cylinder head. connected under manifold,must remove manifold.
Near bottom of trans bell housing right side
X5 does not equipped with V6 engine. It's I-6...
Mine went into transmission failsafe mode, and takes off very very slow
can one a bmw 330ci that have the eml sensor on
It tells the ecm where #1 cyl is and when to fire the plug and the injector.