answersLogoWhite

0

Under the coil pack on the left hand side (pass. side)of the moter

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Where is the camshaft position sensor on a 2005 Kia Sorento?

under upper timing belt cover, driver side 3.5 eng


What else would cause chirping noise from engine on 97 XLT V8 AWD 5.0 ENG replaced serpentine tensioner and water pump now check engine light on?

Camshaft Position Sensor / syncronizer


You replace the iat sensor fron a Honda civic vt and reset the check eng light but do not clear the code still in?

problem is not sensor but is in wiring to sensor or computer


Where is the oil sensor on a 1993 Dodge Ram with 318 Eng?

Back of the block, next to the distributor.


Is the oil pressure sensor on a 2003 Avalanche the same as on a 2002?

No for the 2003 ACDELCO Part # 12573107 SENSOR,ENG OIL PRESS. For 2002 ACDELCO Part # D1818A {#12562267} SENSOR,ENG OIL PRESS GA. If you don't want to pay dealer prices checkout Rock Auto Parts ;-) Follow the link.


On a 1992 Chevy lumina with a 3.1 eng where exactly is the crankshaft sensor located?

behind the harmonic balancer


Where is the intake air sensor located on the 4.7 jeep eng on a 2002 models?

In the intake snorkel tube.


Chevy silverado 2500 hd 2002 6.0 eng I need to know where is the camshaft position sensor located.?

Climb up and lean over the top of the engine and look at the top right rear corner of the intake and you will see the oil sending unit. The cam sensor is tucked under the corner of the intake just alittle and it is beside the oil sending unit. It is hard to see but it's there.


Where is the knock sensor on a 1986 ford f150?

what eng. do you have? if it is a 5.4 or a 4.6 it is under the intake manifold on the passenger side.


Where can you find the temperature sensors in your 1991 Ford Escort 16 EFI?

If you are talking about the Engine coolant temperature sensor (ECT) it is mounted in the following locations: 1.8L eng. in the cylinder head. 1.9L eng. threaded into the heater hose inlet pipe. and the 2.0L eng. at the left rear of the engine


Where can you find a picture of the knock sensor in Pontiac Grand Prix?

If this is the 93 Grandprix with the 3.1 eng. the Knock sensor is located just under the manifold back next to the fire wall you can see it from the bottom. It's hard to get to if you have small hands you can touch it from the bottom. However it is much easer to let the eng. cool down lean over the eng. close to the front of the eng. if you can get your hand and arm back there it is much easer to remove and replace from that point. I know I did one from the bottom it took 1.5 hours from the top it less than 15 minutes.


Have a Chevrolet cavrlar z 24 2.8 liter when you come to a stop the eng dies?

adjust the idle i think you need a o2 sensor