Dodge Intrepid
Nissan Altima
VW New Beetle
Crankshaft Sensors

Where is the camshaft sensor on a 2004 intrepid?

121314

Top Answer
User Avatar
Wiki User
2009-08-08 16:34:39
2009-08-08 16:34:39

On the front of the driver's side head. There should be two wires going to it.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Front Driver's side Cylinder Head. Thank you

User Avatar

how to replace a map sensor on a 2004 dodge intrepid.

User Avatar

CMP : camshaft position sensorCKP : crankshaft postion sensor.CMP : camshaft position sensorCKP : crankshaft postion sensor.

User Avatar

On a 2004 Chevy Astro, the camshaft sensor is located in the front of the engine. It is on the left side of the timing cover behind the camshaft sensor.

User Avatar

yes just pull it out and put the new 1 rite in... just like replacing your batteries to your t.v remote.

User Avatar

Did you figure out where this sensor is located

User Avatar

1999 dodge intrepid is not starting I change crank and camshaft sensor and it stall will not start what can i do next.

User Avatar

On a 2005 Nissan Maxima where is the Camshaft Position Sensor (Bank 1) located?

User Avatar

Trouble code P0340 means: Camshaft Position Sensor A Circuit (Bank 1 or single sensor)

User Avatar

looks similar to the camshaft sensor, but it's located in the bell housing on the transmission on passenger side.

User Avatar

It bolts to the timing cover on the front of the engine on the driver side. It is a three wire sensor.

User Avatar

Front of the engine, points at the driver side cam sprocket.

User Avatar

drivers side in the timing cover just before the valve cover.

User Avatar

The 2004 Dodge Intrepid oxygen sensor can be found on the back of the air cleaner housing. Remove the wiring harness. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.

User Avatar

where is crankshaft position sensor and camshaft position sensor on a 2004 Jetta 2.0 gl

User Avatar

the camshaft sensors are located on the back of the heads under the air cleaner duct.

User Avatar

No. The camshaft position sensor and crankshaft position sensor tone wheels are different. It may fit, but the engine will not run.

User Avatar

just below the drivers side valve cover plug points to the passnger side

User Avatar

i believe it is on the front timing cover, left side, middle I just changed one for the 2.7 liter engine and found it right in front and at toward the top - opposite the radiator.

User Avatar

location of the camshaft sensor

User Avatar

No Camshaft Position Sensor Circuit Failure

User Avatar

no, there is one bolt that holds it in place, so no need , just a 10mm socket

User Avatar

Camshaft Sensor is used to adjust the timing to to belt stretch

User Avatar

The Camshaft sensor is located in the distributor.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.