answersLogoWhite

0

how to replace a map sensor on a 2004 Dodge intrepid.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the map sensor on a 2002 Dodge Intrepid?

The Map Sensor mounts to the drivers side of the intake manifold plenum.


Where is the map sensor on a 98 intrepid located?

It can be hard to learn the location of all the parts in a vehicle. The map sensor of a 1998 Intrepid is located on the back on the intake manifold, near the transmission dipstick.


What does error code p0107 for a dodge intrepid mean?

MAP sensor circuit low.MAP sensor circuit low.


Where to find MAP sensor on 2004 Chevy Trailblazer?

where is map sensor on 2004 trailblazer


How do you replace the MAP sensor in a 1996 Dodge Intrepid 3.3L?

View Repair Guide http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?partName=Manifold+Absolute+Pressure++MAP++Sensor&pageId=0900c1528006ab35&partId=0900c1528006ab35#hd1-1-3


Where is the map sensor located on a 3.2 liter intrepid?

On the intake manifold on the driver side.


How do you replace map sensor on 96 Nissan Maxima 3.0?

can you tell me were the map sensor


How do you replace the map sensor 0n a 2004 Kia Sorento?

To replace the map sensor on a 2004 Kia Sorento, first ensure the engine is off and disconnect the negative battery terminal. Locate the MAP sensor on the intake manifold, usually near the throttle body, and disconnect the electrical connector. Remove the mounting bolt(s) and carefully pull the sensor out. Install the new sensor by reversing the steps: insert it into place, secure it with the bolt, reconnect the electrical connector, and reattach the battery terminal.


Diagram of the map sensor on a 2004 Dodge Intrepid?

Need to know what motor. Is it the 2.7L or the 3.2/3.5L? Heres a diagram for the 3.5L I think the 2.7L uses the same sensor. http://i27.photobucket.com/albums/c166/TCPMeta/map.png


How do you replace map sensor on 2004 Chevy Colorado?

To replace the map sensor on a 2004 Chevy Colorado, first, locate the sensor, which is typically on the intake manifold. Disconnect the electrical connector and remove the mounting screws holding the sensor in place. Carefully lift out the old sensor, then install the new one by reversing the steps: position it, secure the screws, and reconnect the electrical connector. Finally, start the engine to ensure it's functioning properly.


What is a p0108 trouble code and what to do to fix?

p0108 is map sensor signal high. Replace map sensor


How do you install a map sensor on a 2004 Honda Element?

To install a map sensor on a 2004 Honda Element, first, ensure the engine is off and disconnect the negative battery cable. Locate the MAP sensor on the intake manifold, remove the electrical connector, and unscrew the sensor from its mounting. Replace it with the new sensor, securing it in place and reconnecting the electrical connector. Finally, reconnect the battery cable and start the engine to verify proper installation.