Open your bonnet look where the ecotec cover is to the left of that there will be a wire that goes in a gap that's 4 your cam sensor
diagram of where crank shaft sensor goes on vauxhall vectra 2.o sri 1999 model
Behind the camshaft vernier wheel on the Z19DT 120 engine
Just after the airbox before the air flow sensor
The bulb failure lamp on a 1999 Opel Vectra B?æis located on the dash board. It is an operational amplifier chip.
vectra b is the earlier engine
location of the camshaft sensor
Same as all other cars, it senses crankshaft angle so that the engine control module can apply spark to the fuel at a precise time to achieve full combustion with minimal emissions. there's usually also a camshaft sensor, and many vehicles will use the camshaft sensor if the crankshaft sensor fails to provide limited functionality (limp home mode). If its dead, you'll have to replace it for the engine to operate properly. I don't know if your vehicle has any mileage limits on limp-home mode.
No, there is no camshaft sensor on that model.
Camshaft Sensor is used to adjust the timing to to belt stretch
The Camshaft sensor is located in the distributor.
The 2003 Saturn camshaft sensor can be found on the back of the cylinder head. The camshaft sensor should be labeled as such.
All depending on the year of your vehicle will determine the location of the camshaft position. The camshaft position sensor, or cps, is located just under the head gasket. They are two different sensors, so be sure to deal with the correct one.