0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the canister purge solenoid on a 1998 Chevy s-10?
I think it is on a horizontal frame member near the spare tire.
Where is the evap vent control solenoid on 1998 Oldsmobile intrigue?
The evap purge solenoid is located on the top of the engine. The evap vent solenoid is located in the rear drivers side wheel well, attached to the charcoal canister.
Where is the evap system purge and vent solenoids located on a 1998 Mitsubishi Eclipse gs non turbo 2.0 dohc?
they are both located behind the front right corner of the bumper. there is the purge valve, vent solenoid, and charcoal canister all next to each other.
Where is evap emission vent solenoid on a 1998 Camaro?
Is this reachable at home for chevy 98 camaro Evap purge solenoid
What does 1998 Ford Explorer failed canister vent solenoid mean?
i dont know you tell me?
Where is a pressure control solenoid located in a 1998 Chevy blazer?
Not sure what pressure control solenoid is, could it be the fuel pressure regulator?
Where is the location of the purge valve on a 1998 buick lesabre 3.8 liter engine?
on the bottom of the charcoal canister on the drivers side of the engine compartment.
Why wont a 1998 blazer shift from 4wd to 2wd after the dash button is pushed?
The blazer could have trouble with the shift switch. The shift solenoid could be defective as well. Check both of these for problems.
What causes 1998 Chevy Venture has OBD ll code po 446?
First of all, thank you for including the year make & model, that's always helpful. P0446 Evap vent system performance The most likely culprits would either be the evap canister, vent solenoid, or purge solenoid. All of those parts are through a dealer only. Fuel pressure sensor is also a possibility.
Where is the Lumina evap canister?
On the 1998 Lumina LTV you will find the Evaporative Canister under the car, between the gas tank and spare tire well that protrudes from the bottom of the trunk. Easy to replace. Costs between $65 and $120. If any of the lines are cracked you should replace them with new ones if you can. If you have already replaced the Evaporative Canister Purge Valve located on the top front of the engine, next to the valve cover, and you are still getting an OBD code P1441 the charcoal in the canister may be breaking down and getting sucked into your new purge valve. It is a good practice to replace both the purge valve and the canister at the same time if you can afford to. Paul
What douse the trouble code po1451 on your 1998 3.0l ford ranger mean?
Do you mean P1451 ? - Evap Control System Canister Vent Solenoid Circuit Malfunction
Were is the purge solenoid at on a 1998 neon?
It is located in the cavity behind the passenger side front side marker light between the front bumper and inner wheel well.
