The chip is located inside the ECM (engine control module). There is an access cover on the ECM that will expose the chip. A special tool is used to r & r the chip as not to damage the prongs.
Left rear of the transmission on 2 wheel drive trucks.
Just Drive It
Until it runs out.
in the fuse panel inside drivers door spot #2 transfer case it is labled
I don't think so, given that the engine became computer controlled in 1996. I they are the same size they might bolt up just fine but I'm not sure how much work it would be to convert it to computer control. The Suburban and Silverado drive trains were almost unchanged from 1988 thru 1995 and 1996 thru 2000.
Yes it will, As long as both trucks are either a 1/2 ton or a 3/4 ton, 4-wheel drive are just a 2-wheel drive.
It has 210 H.P.
He has a 2012 Ford F-250Also has a Chevy Suburban and a Tahoe.
hi my 2008 chevy suburban transfer case is blown and automaticly went from auto to low 4wheel drive any one know how to get it two 2 wheel drive the switch does nothing
chevy suburban is mounted on a truck frame so most rear ends from any truck or tahoe which is also a truck will work if it is a late model 6 lug.
where is the over drive solenoid located on a 1989 Chevy Corsica
There are three u-joints on an 88 suburban. These joints are located in the rear wheel drive of the vehicle.