0
What else can I help you with?
Where are the speed sensors located on a 1997 Oldsmobile cutlass supreme?
there programmed into the computer.
Where is the cabin air filter in a 1997 Oldsmobile silhouette?
In a 1997 Oldsmobile Silhouette, the cabin air filter is located behind the glove compartment. To access it, you typically need to remove the glove compartment by unscrewing it or detaching it from its hinges. Once the glove compartment is out, you can reach the filter compartment, which is usually covered by a panel that can be easily removed.
Where is the horn and how do you access it on a 1997 Oldsmobile Silhouette?
There are 2 horns on the 1997 Oldsmobile Silhouette. You must remove the headlight/ turn signal assemblies (2 thumbsrews to remove each one). You will find each horn in the space below the headlight.
How do you replace a rack and pinion assembly on a 1997 Oldsmobile Silhouette?
Gm had a recall on this. Take it to a dealer to do it for free.
Oldsmobile silhouette transmission slips?
engine light is on 1997 olds sillouette tranny slpis code
Where is the blower motor located on a Oldsmobile achieva?
where is the blower motor located a a 1997 oldsmobile achieva
Where is the turn signal relay on 1997 Oldsmobile silhouette?
check your two fuse boxes one is between your passenger door and the dashboard and the othe is located in your engine labelled engine relay center
What does it cost to replace head gaskets on 1997 Oldsmobile Silhouette?
I have a 2002 Olds Silhouette and had to replace the head gasket set 2 years ago. It raun around $1,700.00
Where is the starter relay on a 97 Oldsmobile silhouette?
The 1997 Oldsmobile starter relay switch can be found in the fuse box. The starter relay switch will be at the top of the third column.
Where is the window shield washer fuses located in 1997 Oldsmobile cutlass supreme?
where is the windshield washer fuses located in 1997 Oldsmobile cutlass supreme
Where is the head gasket on a 1997 Oldsmobile Silhouette?
The head gasket on a 1997 Oldsmobile Silhouette is located between the engine block and the cylinder head. Its primary function is to seal the combustion chambers and prevent coolant and engine oil from mixing. To access the head gasket, the intake manifold and cylinder head must be removed, which can be a complex process. It's essential to ensure the engine is cool and properly supported before attempting any repairs in this area.
What do you have to do if your 1997 Oldsmobile silhouette gives you the code p0420?
i m not sure what to do but what the code means is that the catalyst system efficiency is below threshold
