Open the panel in the rear (driver's side) that houses the jack. There is a 4'' x 4'' computer looking box. The sticker on the front will have your 5 digit code in bold writing. It is near the end of the opening so you may need to pull the plastic a bit, and use a flash light!
The 1999 Mercury Sable computer module can be located behind the passenger side dashboard. The dashboard will need to be removed in order to view the computer module.
On a 1999 Mercury Mountaineer : The Powertrain Control Module ( PCM ) is in the engine compartment , passing through the firewall . From the engine compartment , towards the passenger side of the engine compartment , you will see where the wiring harness is bolted to one end of the PCM at the firewall ( most of the PCM is " hidden " behind the glove compartment )
Mercury Mountaineer was created in 1997.
There are two head gaskets in the V 8 1999 mercury mountaineer
According to the ( 1999 ) Mercury Mountaineer Owner Guide : ( the length is 188.5 inches )
What is a gem module for 1999 mercury sable? And what does it control?
looking for a diagram for 1999 Mercury Mountaineer. Need to take the fuse out for the seatbelt alarm, it will not shut off.
The 1999 Mercury Mountaineer owners manual shows : unleaded fuel only - 87 octane as the recommended fuel
The sub woofer size on a 1999 Mercury Mountaineer is 5 inches by 7 inches. Speakers are located in the front and the rear of the vehicle.
To replace the battery cables on a 1999 Mercury Mountaineer, loosen the connectors at the terminals. After this, remove the other end of the cables and install new ones.
On a 1999 Mercury Mountaineer : The ELECTRIC fuel pump is INSIDE the fuel tank . It is installed through an access hole on the top of the fuel tank
take it off