in the rear left wheel compartment where the jack is its mounted to a bracket up above the wheel well its a white plastic box with a wire harness plugged into it
The 2007 Ford Explorer computer module is located below the dashboard, on the passenger side. The computer module is in a rectangle steel box.
at the left side of rear compartment where the jack is. on the sticker of the the yellow box.
On a 1994 Ford Explorer, the computer module is behind the kick panel on the passenger front side.
The computer module for the keyless entry system on the 2006 Ford Explorer is behind the rear passenger seat. It is located under the seat belt panel.
The Ford Explorer computer module is located on the firewall under the hood in the center on some models. On other models the computer module is behind the glove compartment. The glove compartment has to be removed (open it as far as possible to pop it off the back hinge) to access the computer module.
The Ford Explorer was produced from the years 1990 to present. The wiper motor pulse board module in a 1998 Ford Explorer 4.0 L is located on the firewall, behind the engine in the middle.
On a 1998 Ford Explorer : You can seeone end of the Powertrain Control Module ( PCM ) in the engine compartment . It passes through the firewall , from the engine compartment end you can see where the wiring harness is bolted to it , and most of the PCM is " hidden " behind the glove compartment
The idle is controlled by the powertrain control module ( computer )
In a 1998 Ford Explorer : The RAP module ( Remote Anti-theft Personality module ) is used with your anti-theft system and your keyless remotes ( each vehicle with keyless entry has it's own factory code )
where does a shift module go in at on a 1995 ford explorer xlt 4.0 2wd
I believe that is in the center stack of the dash , behind and to the left of the radio
The powertrain control module on 1991 and 1992 Ford Explorer is in the right front passenger area behind the right front kick panel