I'm assuming you are looking for the keyless entry code? If so, that module is located behind the trim panels on the rear passenger side pillar, just below where the outboard seat belt shoulder harness exits. these trim pieces can be pulled out far enough to see the code attached to the module. No tools are necessary, as these plastic panels just snap in place. Hope this answers your question. Dave K.
The 2007 Ford Explorer computer module is located below the dashboard, on the passenger side. The computer module is in a rectangle steel box.
On a 1994 Ford Explorer, the computer module is behind the kick panel on the passenger front side.
The computer module for the keyless entry system on the 2006 Ford Explorer is behind the rear passenger seat. It is located under the seat belt panel.
The Ford Explorer computer module is located on the firewall under the hood in the center on some models. On other models the computer module is behind the glove compartment. The glove compartment has to be removed (open it as far as possible to pop it off the back hinge) to access the computer module.
The 2005 Ford Explorer computer is located beneath the dashboard, on the passenger side of the passenger compartment. The computer is house in a sealed box.
The idle is controlled by the powertrain control module ( computer )
where does a shift module go in at on a 1995 ford explorer xlt 4.0 2wd
The powertrain control module on 1991 and 1992 Ford Explorer is in the right front passenger area behind the right front kick panel
In the Jack compartment on a 1996
The idle speed is controlled by the powertrain control module ( computer )
The 2005 Ford Explorer has 12 valves.
The 2005 Ford Explorer has a V6 engine.