Not sure what you mean by coolant port... Antifreeze can be added to the cap on the passenger side of the radiator if it is low and the reservoir on the driver's side should be filled to the line when cool
where do i find the low side service port on a aztek
Dexcool unless you flush thoroughly and use the green stuff
Coolant Temp below thermostat regulating temp.
Pontiac Aztek was created in 2001.
you will find the fuel port behind your power steering pump.
Green. The 3.4 motor does not have any aluminum parts internally, so green is standard.
fuse abs pontiac aztek 2002 located
To replace the coolant bypass pipe on a 2003 Pontiac Aztek, first, ensure the engine is cool and disconnect the battery. Drain the coolant and remove any components obstructing access to the bypass pipe, such as the air intake duct or engine cover. Unscrew the old bypass pipe from the engine block, clean the area, then install the new pipe with a new gasket if needed. Reassemble everything, refill the coolant, and check for leaks.
It is under the air box. First remove the air box, then move the coolant reservoir to the left, remove the brace, then you have access to the cover of the pcm.
Where is the fuel shut off on 2002 aztek
To replace the thermostat on a 2001 Pontiac Aztek, first, ensure the engine is cool and disconnect the negative battery terminal. Then, drain the coolant from the radiator and remove the upper radiator hose connected to the thermostat housing. Unbolt the thermostat housing to access the thermostat, replace it with a new one, and reassemble everything by reversing the disassembly steps, ensuring to refill the coolant and check for leaks afterward.
To change the radiator in a Pontiac Aztek, start by ensuring the engine is cool and disconnect the battery. Drain the coolant by removing the drain plug at the bottom of the radiator and disconnect the upper and lower radiator hoses. Remove any mounting bolts and the fan assembly if necessary, then pull out the old radiator. Install the new radiator by reversing the process, reconnecting the hoses, and filling the system with coolant.