answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where is the coolant sensor on a 95 firebird?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Were is the coolant temp sensor on your 95 firebird?

it is located on the driver side between cylinders one and three


Where is the coolant sensor on a 95 Chevy silverado located?

The 1995 Chevy Silverado coolant sensor is located on the front of the engine. The coolant sensor will be a few inches above the thermostat housing.


Where is 95 Saturn low coolant sensor location?

he radiator


Where is the coolant temperature sensor located in a Pontiac firebird 2002?

on the 3800 V6 its below the throttle body


95 firebird 3.4 cranks no start no injector pulse no spark?

Check the 95 Firebirds crank position sensor first. If the sensor is bad then the injectors won't turn on and there will be no spark.


What causes code 22 engine coolant temp sensor out of range 95 neon mean?

A failed coolant sensor, failed wiring, or a failed computer.


Low engine coolant when coolant is full on a 95' olds aurora?

Bad sensor? Should be located at the bottom of the coolant recovery tank


Where is coolant temp gauge sensor on 95 town car?

The 1995 Lincoln Town Car coolant temperature gauge sensor can be found on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.


Where is the starter relay in a 95 firebird 3.4?

where is the starter relay on 95 firebird


Where is the low coolant sensor on the 95 firebird formula?

passenger side of radiator engine side about 4 to 5 inches down it has a clip on it just un snap and snap new one in after draining radiator about 5 inches takes about ten minutes.


When ford probe 95 engine 2.5 GT is hot -is not working?

Temperature coolant sensor...


How do you change coolant sensor 96 firebird?

the cool sensor is located under the throttle boby on the front of the engine. disconect the wiring harness and use a box wrench (19mm) to remove it