The temperature sensor is located on the top of the engine, near fuel filer. Someone told me that there is two of them, one for the PCM and one for the cluster but I didn't found the other one.
On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.
A 1997 Dodge with a Cummins diesel does not have an oxygen sensor.A 1997 Dodge with a Cummins diesel does not have an oxygen sensor.
1997 Dodge diesels come with the 12 valve cummins engine. It is fully mechanical and does not have a camshaft position sensor. "Dodge cummins diesel forum" is a good resource for dodge cummins owners.
The 2005 Peterbilt M 11 Cummins diesel engine map sensor is located next to the fuel pump. The map sensor should be labeled as such.
a 1993 doesn't have a cam sensor. the crankshaft position sensor is located on the front of the engine directly above the crankshaft pulley
It doesn't have a mass airflow sensor.
A 2000 Dodge Ram diesel does not have an oxygen sensor.
On the fuel filter!
No such part on a 1993 Cummins
In 2004, the Dodge Cummins Diesel was not equipped with an oxygen sensor. The 2007.5 and newer Cummins 6.7 liter Bluetec diesels have an O2 sensor in the downpipe. Typically, only particulate filter equipped diesels have O2 sensors.
Cummins (OEM) 12 valve (single wire) oil pressure sensor is located below the injection pump and could be in front of or behind injection pump support bracket. The location was determined by the factory installing the engine. Cummins (OEM) 24 valve (three wire) oil pressure sensor is located below the ECM.
go to: http://www.med-worldwide.com/product634.html shows where it is.