0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why is the heat cold on a 2006 Chevy Impala?
Low on coolant, Stuck open thermostat, Plugged heater core, Faulty blend door actuator,
What do you put in a 2006 impala coolant reservoir?
Coolant. Most likely DexCool.
Where is the engine coolant temperature sensor on a 2004 impala?
It is on the intake manifold near the thermostat.
What does the code mean p0128 on an 03 impala?
Trouble code P0128 means:Coolant thermostat (coolant temp below thermostat regulating temp)
Where is the bleeder screw for the coolant on a 2006 impala?
need to know what engine.
Where is the coolant sensor on a 2002 Chevrolet Impala with a 3.4 engine?
It is on the intake manifold near the thermostat housing.
Where is the engine coolant temperature sensor on a 2004 Chevrolet Impala?
It is located in the intake manifold near the thermostat housing.
2002 Chevy Impala 3.4L show the code P0128?
Trouble code P0128 means:Coolant thermostat (coolant temp below thermostat regulating temp)
Why is the heat not working on your 2006 Chevy Impala?
Assuming the blower motor is working, it could be low on coolant, a stuck open thermostat, a plugged heater core or a faulty temp blend door actuator.
How do you change the thermostat in a 2006 Chevrolet Impala?
Drain the radiator into a container. Remove the upper hose at the engine end. Remove the 2 bolts in the thermostat housing and remove the thermostat. Clean both surfaces and install the thermostat "O" ring. Install the thermostat ,housing and 2 retaining bolts. Install the upper hose and fill the coolant recovery tank.jd
Image of where thermostat is located on 2006 Chevy impala?
On the 2006 Chevy Impala, the thermostat is located in the hose that is directly above the middle cylinder. It is on the driver's side of the engine compartment right behind the alternator. Look for a long hose that goes from the radiator to that location.
Where is the engine coolant temperature sensor on a 2002 Chevy impala?
Intake manifold, near the thermostat housing. Should have two wires.
