Coolant thermostate you can find by right side the motor if you look from front of the car. You have to dismantle air filter, two rubber hoses to refrigerateur and you can see the double aluminum pipe with thermosensors in it. There is no gaskets but O-ring onlj. Thermostat is cylindic form inside double pipe collector and pipe form about 5cm diameter.
You can get a code to unlock the start-up for a Citroen Xantia V6 Aut 1997 in the vehicle's official owner's guide. You can also check with the manufacturer to see if the code is available.
it is threaded into the thermostate housing.
how do you change a thermostat on a olds cutlass supreme 1983
remove the hose and look into the housing the thermostate should be there
Drain the coolant, remove the two bolts holding the thermostate on, pull it out, replace thermostat along with o-ring, refill coolant, bleed air from coolant.
how do i bleed my accord v6 2000 coolant system, its has air and the rev's gone up & down......
Where is the coolant temperature sending unit in a 96 toyota tacoma 3.4L V6
Citroën Xantia was created in 1993.
On a 1.8T, swing the alternator out of the way, and it's at the top of the coolant pipe. On the V6, it's behind a flange under the timing cover. You pretty much need to take the front end off the car unless you have really skinny hands.
The engine coolant drain plug on a Mitsubishi V6 engine is located on the bottom of the radiator. This allows for coolant to be quickly and easily drained.
Refer to your user and service manual to see where the coolant temperature sensor is located in the VW Touareg V6.
if the thermostate is stuck open it wont allow the coolant to reach a certain temp. which could cause the heat to not work to well.