Cord a to cord b to cord e
165
a cord b cord c cord then all over again
To connect your guitar to an amplifier using a guitar cord, simply plug one end of the cord into the output jack on your guitar and the other end into the input jack on the amplifier. Make sure both the guitar and amplifier are turned on and adjust the volume and tone settings as needed for the desired sound.
Guitar Patches or Patch Cords are simply just the cord going from the guitar to the amp.
There is a power switch on the guitar
Guitar is in concert A and the tenor saxophone is in Bb, so to transpose music from guitar to tenor saxophone you move up three semitones (A, B, Bb)
To connect your guitar to an amplifier using a guitar cord, plug one end of the cord into the output jack on your guitar and the other end into the input jack on the amplifier. Make sure both the guitar and amplifier are turned off before connecting to avoid any unwanted noise. Adjust the volume and tone settings on both the guitar and amplifier to achieve the desired sound.
they earn 2000 a concert
Not quite sure what your asking, If its buzzing because the jack is the problem then you probably need to re solder the wires in either the guitar or the cord, if its the cord it would be easier to just buy a new cord. If its buzzing when the guitar isn't plugged into the amp the try adjusting the truss rod.
Longer sound wave produce
Chord. As in a group of notes which harmonise.