0
On the drivers side low on the motor and to the rear. It is the only wire in that area. It is held on by a single bolt. Len On the drivers side low on the motor and to the rear. It is the only wire in that area.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the crank shaft position sensor located in a 98 Cadillac catera?
http://www.cadillacforums.com/forums/cadillac-catera-cimarron-forum/67854-98-catera-crankshaft-position-sensor-replacement.html
How do you replace the fuel pump in a 1997 Cadillac Catera?
Check your crank shaft sensor first.
Where is the crank position sensor located on a Cadillac deville?
where is the crankshaft angle sensor located on a 1997 cadillac deville.
Theres no fuel getting to the pump on 1997 Cadillac Catera?
Will it start after setting awhile? Check the crank shaft sensor.
After warm up Catera Won't crank.?
I have a 1999 Catera. When this happens it is almost always the crankshaft position sensor. Check on www.cadillacforums.com for more info.
Where is the crank sensor on a Cadillac Catera 2000?
On the low rear of the engine. It can be accessed from under the car only. It is held on by a single bolt. Len
2001 Cadillac Catera sport starting problems?
If you have to crank and crank to get it started look for the coolant temperature sensor and change it. This is just one reason for hard start and is the most popular reason. Other reasons could be plugs, plug wires, coil pack, crank sensor, cam sensor and more.
Where is the crank position sensor for a 95 blazer?
Where is the crank position sensor hole on a 2003 Blazer
On 2003 Cadillac CTS cadillac quoted you 438 for crank shaft position sensor w labor is this accurate and will this help jiggle while idling?
I just had to replace my Crankshaft position sensor and the part was $48 and the labor was $106. To answer your question, yes.
Is the throttle position sensor and crank position sensor the same thing?
No, the throttle position sensor detects how far open the intake is. The crank position sensor watches the rotation of the crankshaft.
What is the location of the crank position sensor on a 1990 Firebird 3.1?
it does not have a crank position sensor. it uses the ignition control module as a crank sensor. it is in the distributor cap
1994 s10 blazer crank position sensor?
The crank position sensor is on the front of the engine. It is behind the crank pulley on the left side.
