crank sensor is located at the top of the transmission bell housing,two hex bolts that hold the crank sensor in place.
The crankshaft position sensor is located on the rear of the engine. It is mounted just above the oil pan on the engine block.
The crank sensor will be located iether behind the harmonic balancer or right on the side of the engine block
It is located on the bell housing on the driver's side of the vehicle.
The 1995 Oldsmobile Aurora 4.0 liter engine crank sensor is located on the back of the crank. You will need to remove the rear engine cover in order to view the crank sensor.
no
not behind the bell housing ?
THE CRANK SESOR IS LOCATED BEHIND THE STARTER ON THE 2.2.
Where is crankshaft position sensor located on a 1996 Toyota corolla 1.6 liter?Read more: Where_is_crankshaft_position_sensor_located_on_a_1995_Toyota_corolla_1.6_liter#ixzz1nWxVCKMW
i need to know. my1996 1600 geotracker engine carries a crank sensor, i am replacing it with a vitara engine but it does not carry a crank sensor. the vitara distributor only has two wires. how do i configure, cause the geo distributor has 7 wires
The 1999 Range Rover 4.6 liter engine crank shaft sensor is located on the back of the engine. The crank shaft sensor is behind the rear engine cover.
The sensor is behind the front pully under the crankshaft. It's held in by one bolt and takes about 5mins to change.