0
The crankshaft sensor on a 1994 chev cavalier in located at rear of engine near firewall, just below the coil pack on a 2.2L (just above the oil pan. There is one screw and be careful there is an o-ring and very long end inside engine, it may break if you try to pry it out.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What does tha crank sencer do?
What will be the sign when the crank sencer is not working?
Can you bypass a crank sencer on a 1997 Chevy truck?
No you can not.
Why is a Chevy Cavalier shutting down?
check fuel sencer
Where is the oxygen sencer located on 1998 cavalier?
just behind the converter
Crank position sencer location on 2003 Pontiac GTP?
The crank sensor is located behind the hamonic balancer
What causes no spark in plugs on a2000 Mitsubishi Galant?
pcm or crank sencer
Why 96 Dodge Caravan is not firing?
crank sencer, coil pack, or ecm
Where is the crankshaft sencer on a 1993 Chevy 454 located?
That year did not have a crank sensor on it.
Does a 1994 4.3 vortec have a cam shaft sencer?
It is in the distributor.
What is wrong when the engine of a 1989 buick century 3.3 liter cranks but get no fire?
crank sencer
How do you install the crankshaft position sensor on a 1987 Buick Grand National?
rotate the engine until you have the gape on the interupter ring over the crank sencer. remove the crank sencer assembley that bolts to the block with the sencer attached. ( do not take the 5/16 bolt loose that holds the sencer.(unplug the wires to the sencer first. once yu have remover the sencer assembley from the block you can tell how to set up the new sencer. mark the sencer with a knife or paint pen so you can see how to set up new sencer. Now you are readty to remove the 5/16 bolt. back the bolt out and remove the sencer for the bracket. pay attention where you marked the old sencer. Mark the new sencer in the same location and place it back in the bracket,( Be sure to alighn the sencer exactly as the old on. Then tighten the 5/16 bolt back..DO NOT over tighten this bolt. now reinstall assenbley back onto the block. Be sure not to break the window of the new sencer as you reinstall. it will be a tight fit but it will go. Take a flywheel tool and turn engine BY HAND to make sure you have properly set up your sencer. As long as it does not hit it will be good. if it does hit, back off the 5/16 bolt and move the sencer until it does not make contact with tha interupter ring on the crank shaft. plug your wires back into the sencer. start engine an have fun.. Hope this help.
How do you replace a crank sensor on a 98 cavalier?
Bob
