umm, check the trunk, it might be there right beside the moldy fries.
yes it fits, they even fit in a ford probe there all the same engine, I currently have a 94 Mazda 626 with an 95 mx6 engine, 4 banger, but the same goes for v6,
I had the same problem and found out it was the crank shaft sensor!
You need a big Socket (32MM I believe). Once you take off the nut the Drum will come right off. I have '95 MX6. Yes, a 32MM socket is needed. However, it is also possible that a large jaw clamp puller may need to be used in order to dislodge the bearings from the spindle. They seem to get stuck on there.
95
try taking the ignition control module to oreilly's to have it tested. How long ago were the plugs wires cap and rotor replaced?
how to ins toll a crank sensor on a 95 Mitsubishi 6v, but first of all my car crank to the point that it wanted to start but it does not start what might be the problem.
The 95 model doesn't have one externally. It's called an optical pickup and is part of the distributor. It can't be purchased separately.
A crank sensor was not USED on a 1995 model.
Where is the crank position sensor hole on a 2003 Blazer
Mazda Millenia 95 not starting put another motor in it just turning over? its probably the distributor is bad.
Trade it in for a new Mazda RX-8.
It is a magnet that puts your engine back in the correct position once you turn your vehicle off so it will starrt again,I've had this problem twice..