Want this question answered?
It is behind the starter.
Location of crank shaft position sensor of a Nissan altima 2.5 2004? send diagram please
The crank shaft position sensor is just above the oil filter at the tail end of the starter
It is bolted in the side of the block BEHIND the starter. You will have to REMOVE the starter.
bottom front on passanger side behind a/c compressor.
It is on the bottom left side of the timing cover, behind the balancer.
hi i have a 2004 mitsubishi l200 ediesel that wont start,turns over but not firing,been told its the crank shaft position sensor
Back of the block, about two inches above oil pan.
It is under the timing belt cover near the crankshaft pully / harmonic balancer.
Your knock sensor is located undernesth the air intake manifold on top of the engine block. This goes for 2000-2004 xterra V6 3.3L models. Hope this helps.
where is the crank position sensor located on a 2004 hyundai v-6 2.7 engine
How_do_you_replace_a_crank_sensor_on_a_2004_jetta