It mounts to the top rear of the transmission bell housing.
The crankshaft is the largest part in the bottom of the engine.The crankshaft is the largest part in the bottom of the engine.
It is on the top rear of the bell housing.
Top rear of the bell housing.Top rear of the bell housing.
The crankshaft position sensor measures the rotational position of the crankshaft for the engine computer. That info is required for fuel and ignition timing.The crankshaft position sensor measures the rotational position of the crankshaft for the engine computer. That info is required for fuel and ignition timing.
Back side of the engine, just above the oil pan.
When a crankshaft sensor is bad the engine will not run. The sensor is not usually intermittent, it is either good or bad.
The Chrysler Sebring knock sensor is located in the engine valve or cylinder located at the back of the motor. This part is in this position next to the engine valve so the sensor can feel the vibration of the engine.
If a Chrysler Sebring has a supercharger it is aftermarket and not factory.If a Chrysler Sebring has a supercharger it is aftermarket and not factory.
Passenger side of the bell housing, behind the engine.
The 2.7L out of a Chrysler Sebring or Dodge Stratus.The 2.7L out of a Chrysler Sebring or Dodge Stratus.
by the engine
A Sebring is a Chrysler not a Pontiac. It can have a seperate belt depending on the year and engine.A Sebring is a Chrysler not a Pontiac. It can have a seperate belt depending on the year and engine.