It should be located on the passenger side of the transmission bellhousing, about midway between the top and bottom of the bellhousing.
Only 4 cylinder engines had crankshaft position sensors in 1990 Dakotas and it was located on the driver's side of the transmission bellhousing, midway up, right where it bolts to the engine block. Follow the wire and exhaust downpipe to it
On the right side of the engine Block manafold
Crankshaft sensor is located on the right side of the cylinder block behind or under the starter. It is fitted into the rear crankshaft oil seal hausing.
on the passanger side. it i located on the trans housing where the engine and trans meet.
There are ( 2 ) timing CHAINS ( one CHAIN to each cylinder head from the crankshaft ) located at the front of the engine
The variable reluctance sensor is the same as the crankshaft sensor on the 92 Ranger. It is on the front of the engine beside the crankshaft pulley.
The crankshaft position sensor on a Dodge 5.9L V8 is located behind the passenger side cylinder head, and it aims at the flywheel through a hole in the bell housing.
The crankshaft is located inside the lower half of the engine. The engine must be removed and disassembled to gain access to the crankshaft.
The Crankshaft Position (CKP) sensor is located at the right-rear side of the engine cylinder block CKP Sensor Location/Removal/Installation - 4.7L V - 8 Engine It is positioned and bolted into a machined hole in the engine block
Inside the oil pan mounted on the engine block.
inside the oil pan.
The crankshaft is the largest part in the bottom of the engine.The crankshaft is the largest part in the bottom of the engine.