0
Where is the crankshaft sensor located on a 2004 Suzuki Verona EX?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace a crankshaft sensor on a 2004 suzuki Verona?
its on front of head drivers side of car just under edge of plastic intake remove bolt from it and pull out of head
Where is a crankshaft sensor located on a Nissan almera?
Where is a crankshaft sensor located on a nissan almera 2001
Where is the crankshaft sensor located in suzuki XL7?
Per Suzuki Dealer ...Under the Intake Manifold near back of Engine Block, Unless you have an all wheel drive These are supposed to be internal.
Where is the crankshaft sensor located on a 1988 Oldsmobile cutlass supreme?
where is the crankshaft sensor located on a 1988 cutlass supreme
Where is the crankshaft sensor located on a 1993 Chrysler lebaron le?
The sensor in the distributor is the crankshaft position sensor.
Is replacing crankshaft sensor in 2004 Nissan Quest difficult?
Where is the crankshaft sensor located
Where is the TPS Sensor located on a 2004 suzuki Verona?
There is a butterfly valve in the air intake that the accelerator cable ends at. The tps or throttle position sensor is on the opposite end of the axis from where the throttle cable attaches.
How do you repair crank sensor on Renault auto scenic?
2000 suzuki vitara 2.0 crankshaft sensor
Where is the crankshaft position sensor located in a 2003 Kia Rio?
how to replace the crankshaft position sensor located in a 2003 kia rio
Where is the crankshaft position sensor located on a 2002 Audi tt?
Where is the crankshaft position sensor located on Audi 2002 Audi TT
Where is the crankshaft sensor located in a 2001 Chevy Impala LS?
crankshaft sensor is located just behind the crankshaft pulley on the front of the engine(passenger side of vehicle).
Where the crankshaft position sensor is located on 2005 Kia Sedona?
The crankshaft position sensor is located behind the timing cover and above the crankshaft gear. the timing belt my have to be removed to access the bolts on the sensor.
