the crankshaft sensor for 1995 Ford Thunderbird is located behind the powerstreeing reservior. you have to unscrew the power streeing reservior and gently move it to the side with out causing damage to the hoses. below the vavle cover you should see it. it should take about 20 to 30 mins. to replace. take your time! i hope that these information is helpful.
According to my Chilton repair manual , the crankshaft position sensor is used to determine crankshaft position and crankshaft RPM
the crank shaft position sensor should be behind A/C compressor.
The crankshaft position sensor is located at the front of the engine close to the crankshaft damper
top rh rear of the engine on throttle body.
Where are the vacuum hoses on a 1995 ford thunderbird 4.6l engine?
A 1995 Ford Thunderbird is OBD I , EEC IV
Crankshaft Sensor Location 1995 aerostar 3.0 l videos
For a 1995 Ford Thunderbird , 4.6 : I believe that is rated at ( 205 horsepower from the factory )
The physical position of the sensor is behind the water pump pulley, where you can see the the cable connection on the cover of the crankshaft and camshaft gears.
Try a factory shop manual from AUTOBOOKSONLINE.COM.
"Where is the crankshaft position sensor on a 96 ford probe SE?"
need to know the location of the crankshaft sensor on a 2003 ford escape