answersLogoWhite

0


Best Answer

if its the 3.5L the sensor is right on top, at the front of the engine. the cam sensor is near it just to the driver side of the top of the engine. The intake has to be loosened enough to get the cam sensor out form under it. The crank sensor is easier to get out.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the crankshaft sensor on a 2002 Dodge Intrepid?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the crankshaft position sensor on a 2002 Dodge Intrepid with a 2.7L engine located?

It's located at the right (passenger) side of the transaxle bellhousing.


Where is the maf sensor on a 2002 Dodge Intrepid?

It doesn't have a mass airflow sensor.


2002 dodge intrepid knock sensor?

It is under the intake, between the heads.


Where is the map sensor on a 2002 Dodge Intrepid?

The Map Sensor mounts to the drivers side of the intake manifold plenum.


Can a camshaft sensor and a crankshaft sensor for a 2002 Dodge Intrepid 3.5 not be insynce?

if your timing belt jumped one tooth or timing belt was installed incorrectly you will be out of sync also a defective timing belt tensioner will cause sync problems


Where is the knock sensor on a 2002 Dodge Intrepid 3.5 L?

Under the intake, between the heads.


2002 Dodge Intrepid o2 sensor bank 1?

Bank 1 is the pass side.


Where is the oxygen sensor located in a 2002 Dodge Intrepid?

There are four oxygen sensors on a 2002 Intrepid. There is one before, and one after the catalytic converter on each side of the engine.


Where is the camshaft position sensor on a 2002 Dodge Intrepid?

CRANKSHAFT POSITION SENSOR The crankshaft sensor is located on the passengers side of the transmission housing, above the differential housing Crankshaft Position Sensor The bottom of the sensor sits above the drive plate REMOVAL Disconnect electrical connector from crankshaft position sensor. Remove sensor mounting screw. Remove sensor. INSTALLATION Install sensor and push sensor down until contact is made with the transmission case. While holding the sensor in this position, install and tighten the retaining bolt to 12 N·m (105 in. lbs.) torque. Connect electrical connector to crankshaft position sensor.


Will 2002 dodge intrepid wheels fit 2001 Dodge Intrepid?

Yes


What does 2002 dodge intrepid trouble code P0151 mean?

O2 sensor circuit low voltage (bank 2 sensor 1)


How much does an oxygen sensor cost for a 2002 Dodge Intrepid?

For a direct factory replacement..........about $85.00. You need 4 of them.