Wiki User
∙ 2015-05-26 11:19:14The crankshaft position sensor is on the top driver side of the transmission bell housing.
Wiki User
∙ 2015-05-26 11:19:46Usually a crankshaft sensor is located on the bellhousing of the transmission
Top driver side of the bell housing.
You can not. The crankshaft position sensor is required to run the engine.
It is in the distributor.
paste this into your browser...i could not get the link box to take.. but this should ansewr the question on the o2 sensor
No diagram is needed. It will be on the top left/right transmission bell housing.
The engine coolant temperature sensor is the sensor that is screwed into the thermostat housing on the top front of the engine.
it is located on the top of the bell houseing at the back of the block
If the crankshaft sensor is dead the engine will not start
No. The crankshaft position sensor is required for the engine to start and run. The engine computer uses it for fuel and ignition timing.
The oil pressure sensor on a 1997 V8 is on the top rear of the engine next to the distributor.
yes same thing