paste this into your browser...i could not get the link box to take.. but this should ansewr the question on the o2 sensor
Cherokee Laredo, no. Grand Cherokee Laredo, yes.
its on the bell housing,on the tranny,driver side.towars the top,held in by one bolt.sets inside the bell housing.
There is no such thing as a 2002 Cherokee Laredo. The last year for the Cherokee was 2001, and the last year it came with the Laredo trim was 1992. I have a 2003 Cherokee Laredo so this awnser makes no sense at all. Do you have a GRAND Cherokee Laredo? Those are still being made. They are not the same as the Cherokee.
yes There was also a Laredo package for the XJ Cherokee in the 1990's.
It is not equipped with a fuel switch.
The crankshaft position sensor is on the top driver side of the transmission bell housing.
Usually a crankshaft sensor is located on the bellhousing of the transmission
No diagram is needed. It will be on the top left/right transmission bell housing.
To replace the crankshaft position sensor on a 1994 Jeep Cherokee Laredo with a 4.0-liter engine, first disconnect the negative battery terminal to ensure safety. The sensor is located on the bell housing of the transmission, near the starter motor. Remove the electrical connector and the retaining bolt for the sensor, then pull it out. Install the new sensor by reversing the steps, ensuring a snug fit and reconnecting the battery.
It is on the top passenger side of the bell housing.
Top driver side of the bell housing.
Cherokee Laredo, no. Grand Cherokee Laredo, yes.
It Is In The Gas Tank
yes same thing
Rear of the jeep
It is in the distributor.
in a toilet