Had the same problem after looking all over finly went to the library. It behind the staster.
Took me about an hour to change mine, but it was the first time.
I have Olds Intrigue 2000 3.5L. Needed to replace faulty crankshaft sensor.3.5L engine has two of them. If engine is hard to start cold or hot and engine light is OK.Very common problem for this engine in Aurora 3.5 and Intrigue 3.5 is crankshaft position sensor. Which is located above and behind starter. Starter must be removed first.------------------------------------------------------------------------------------------------------------AnswerLower right hand side of the engine just above the oil pan. Theres a single bolt that holds it in.
On the air intake filter box
ON MY '99 3.5, IT'S BEHIND THE STARTER.
On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.
The camshaft sensor on the 99 Olds Intrigue is located on the engine block. It is under the starter, which has to be removed to locate the camshaft sensor.
You have to drop the starter on the front bottom driver side of the engine... next to the transmission. The crank sensor is about in the middle of the block. One bolt holds it in.
there is none. the speed sensor is in the tranny
To relearn the crank position sensor on a 2000 Olds Intrigue, you typically need to use an OBD-II scanner capable of resetting the engine control module (ECM). Start by disconnecting the battery for a few minutes to reset the ECM, then reconnect it. After that, allow the engine to idle until it reaches operating temperature and then drive the vehicle under various conditions to help the ECM recalibrate and relearn the crankshaft position sensor data. Always refer to the service manual for specific procedures and requirements.
134a
$300 with labor
Only the Olds Intrigue with the 3.5 L