On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.
The camshaft sensor on the 99 Olds Intrigue is located on the engine block. It is under the starter, which has to be removed to locate the camshaft sensor.
there is none. the speed sensor is in the tranny
Took me about an hour to change mine, but it was the first time.
Had the same problem after looking all over finly went to the library. It behind the staster.
Only the Olds Intrigue with the 3.5 L
Need clarification on what you are asking.
The map sensor is located on the intake manifold on a 1996 Olds Achieva 2.4 liter. It is in the center of the intake manifold.
Dealerships or junkyards.
I have Olds Intrigue 2000 3.5L. Needed to replace faulty crankshaft sensor.3.5L engine has two of them. If engine is hard to start cold or hot and engine light is OK.Very common problem for this engine in Aurora 3.5 and Intrigue 3.5 is crankshaft position sensor. Which is located above and behind starter. Starter must be removed first.------------------------------------------------------------------------------------------------------------AnswerLower right hand side of the engine just above the oil pan. Theres a single bolt that holds it in.
Yes it has four.Yes it has four.
The oxygen sensor on a 1999 Oldsmobile Intrigue 3.3 liter is in the exhaust manifold/pipes
on the cilynder head besides the engine
If you haven't checked for a diagnostic code you're running the risk of wasting your money.
Yes, it is called the OBD2 code list.
Just remove the console and you can get to it.
Answer confusedhow to change a timing chain in 1999 Oldsmobile intrigue
I found one online for $55 dollars
No car has a "cadillac" converter
The temperature sensor on a 93 Olds Cutlass Cierra 3.3 is located on the back of the engine. It is on the intake manifold.
The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.
On the bottom of the overflow / surge tank (passenger-side fender)
on the front of the oil pan the dumbest place i think
I have a 98 olds intrigue...the camshaft position sensor is located around the middle polley on the left side of the engine. It has one screw. It's fairly easy to install.