0
the accents have distributorless ignition systems to change the igniton coil pack just undo the 4 spark plug wires and undo two 10-11mm bolts and unplug the harness. this should take about 5 min to do
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is a distributor cap located on a 2000 Grand prix GT?
there is no distributer its coil packs
Where is the condenser located on a 2001 Kia Sephia?
air conditioner condenser is in front of radiator ignition condensor should be in side the distributer cap or on side of distributer
Where is the dipstick located on a 1988 Toyota 4Runner?
L/H side under distributer cap in my standard
Where is the coil located in a 1991 Dodge Dakota?
Find the distributer cap. It is the thing all your spark plug wires are connected to. Usually in the center of the distributer cap a wire will lead all the way to the coil. My coil on a 1992 is located below the alternator bolted to the passenger side of the engine.
Where is the camshaft position sensor located on a 2002 Chevy blazer 4.3 v6?
Inside the distributer cap on the back side of it.
Where is the oil sending unit located on a 95 4x4 ram with a 318?
Look near the firewall just left of the distributer cap
Where is the distributer cap for a 1990 olds delta 88 royale?
There isn't a distributor cap it has a coil pack and it is located in the front passenger side it is a rectangular box that the plug wires are connected to
Where is the crank sensor located on 1991 Nissan Stanza?
Inside the distributer. Remove cap and rotor. Remove plate and there it is- small plastic piece.
Where is the ignition coil located on a 1990 Honda Civic LX?
if's it's a 1.5 or 1.6 ltr. it's in side the distributer cap.
What causes bogging down and missing out on start on 2002 Monte Carlo SS?
distributer cap, low octane gas, or spark plugs i would do the distributer cap first.
Where is the ignition control module located on a 1992 Chevy S-10 Pickup?
The Distributer module on "92" S-10 Vin code "W" or "Z" is located on the distributer,you must remove the distributer cap to gain access to the ignition module. Once you have gained access to the ignition rotor it is always necessary to always test the module before replacing it.
What would cause a 1991 Geo Storm to not start in the morning when humidity was high the night before It would start later in the day.?
sounds like you have moisture in the distributer next time it wont start, remove distributer cap, and using a hair dryer, dry inside distributer cap,and inside distributer
