Chevy Silverado
Dodge Ram
Ford F-250

Where is the oil sending unit located on a 95 4x4 ram with a 318?

151617

Top Answer
User Avatar
Wiki User
Answered
2007-01-18 03:32:36
2007-01-18 03:32:36

Look near the firewall just left of the distributer cap

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


It is on the back of the engine, next to the distributor.

On my 1995 Ford Explorer, with the 4.0 L OHV engine, the sending unit for the oil pressure guage is located just below the power steering pump.

if it is an 350 eng it is located at the rear of the intake manifold,on the top of the block, next to the dist.

The oil sending unit on a 2001 Chevy Blazer is just above the oil filter. It is actually located on the diagonal to the oil filter to the upper left.

I'm not a mechanic / technician but I believe the oil pressure sending unit on the Ford 4.0 liter SOHC , V6 engine is on the front of the engine . ( in the area where the lower radiator hose connects to the water pump )

There are two next to the thermostat housing. The one wire sensor is for the gauge. The two wire sensor is for the computer.

Screwed into the engine block under the distributor.

It is on th eback of the engine , next to the distributor.

It is screewed into the top of the engine right behind the distributor. It is very hard to get to.

It is just to the passenger side of the distributor on the rear of the engine.

COuld be a number of things. check out the temp sending unit , check for a faulty thermostat, could be a broken or loose wire from the sending unit. these are the things I would check first. oldtom

I`m not sure but my grandson has removed the sending unit on a 1992 Nesson hard boady XE 4X4 pick-up. He lifted the bed and it is right there on the fuel tank. Only proplem he needs a new sending unit (that holds the fuel pump) Can`t find one every body keeps saying they don`t make them anymore.

The oil pressure sending unit is on the drivers side of the engine below the power steering pump on the 4.0 liter V6 in a 1997 Ford Ranger

It will fit but the manifolds will need changed to match.

The sending unit on one of the front wheels may be loos or not working properly. Make sure that the connectors to the abs sending units are properly seated.

The fuel pump with integrated filter and sending unit is located inside the fuel tank. (not one of Dodge's more intelligent designs) To replace that module, you must first either remove the fuel tank or the truck box.

left of the thermostat in the intake behind the alternator 1 wire on it white connector on 5.2L

the fuel pump is in the tank on the sending unit you may need to drop the tank to access it

where is the 4x4 fuse located in a 2002 ford explorer.

short bed 4x4 318 auto trans 4800lbs


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.