Home
Wiki User
Answered 2012-09-12 17:54:03
It is the round black think with the six spark plug wires attached at the front (passenger side) of the engine.
Your Answer
Related Questions
The cruise control computer module is located on the passenger's side of the engine compartment on a 1993 Mercury Villager.
The cruise control module of a 1993 Mercury Villager is located under the passenger side of the dashboard.
Mercury Villager was created in 1993.
No, the 3.0 V6 in a 1993 Mercury Villager is NOT and interference engine.
There are ( 2 EXHAUST MANIFOLDS ) on your 1993 Mercury Villager 3.0 liter V6 engine
the elictronic control sinsor at on a 93 mercury villager
It is located in the gas tank. The tank must be removed.
The VSS is located on the bottom of the transaxle beside the exhaust manifold.
Yes, the 1993 Mercury Villager was a 1992 Nissan Quest. The last year Nissan used a Carburetor on a Quest. Fuel injection system replaced the carburetor in 1993.
According to one of Ford's websites : The spark plug gap for a 1993 Mercury Villager , 3.0 V6 is : ( .032 inch )
The 1993 Mercury Villager takes 22" replacement windshield wiper blades on both sides front.
The IAT is located in the air intake tube before the MAF.
The MAP sensor should be on the firewall just above the brake booster.
the unit is under the steering column.actually its stuck on the steering column and its a black plug
Near the firewall behind the engine, or under the dash near the heater core.
According to fordparts.com the spark plug gap is ( .032 inch ) on a 1993 Mercury Villager with the 3.0 liter V6
Timing is set by the PCM and is not adjustable.
i found out how to do it.
There is no need to do this normally.
According to one of Fords websites : For a 1993 Mercury Villager , 3.0 liter V6 engine : ( the spark plugs are gapped at .032 inch )
I was looking at one of Fords websites and it shows for the 3.0 liter V6 engine in a 1993 Mercury Villager : The spark plugs are gapped at ( .032 inch )
No , according to the Gates website ( they make timing belts etc. ) the 3.0 liter V6 in a 1993 Mercury Villager ( is an interference engine )
Your Villager has only one O2 sensor located on the front catalytic pipe before the converter. You should be able to look down between the engine and radiator and see it.
There are a couple of reasons why a 1993 Mercury Villager is hard to shift. One reason could be a gear shift cable. Another reason could be low transmission fluid.
How do you get 1000000 robux for free?
Asked By Wiki User
What is the difference between margin and margin?
Asked By Wiki User
Is gold a good investment or will the price of it go down?
Asked By Wiki User
Where is the distributor cap located on a 1993 mercury villager?
Asked By Wiki User
What classification instrument of tongatong?
Asked By Wiki User
What is Hugh hefner penis size?
Asked By Wiki User
What online sites don't ask for cvv?
Asked By Wiki User
What ACHIVR VISB on my bank statement?
Asked By Wiki User
