Want this question answered?
Drive it around about 4 hours
I have a 1981 Glastron bass boat and my serial number is located on the back of the boat on the port side near the top right corner. It was imprinted into the fiberglass. Mine was hard to see, so i took a piece of paper, laid it on the boat, then ran a wax pen over it to get the impression out. Worked like a charm! You might have luck finding it there.
Probably the best way you can possibly drain the tank is to purchase a siphon pump hose and drain the gas into containers. I hope the tank is less than 1/4 full, because that is a LOT of gas to drain! GLiDE
1989 Glastron Futura 227SL
Lukey's Boat was created in 1998.
Row Your Boat was created in 1998.
remove the plug in the rear of the boat! and let it drain. if you don't have a drain plug,you will need to get a bilge pump. wal-mart has a good selection of them and they are cheap.
A "bilge pump" is not automatically on a boat. Every boat does however have a bilge area. It is the area in a boat's hull where water collects. This area is seriously recommended to have a "bilge pump" in it on every boat to pump the water out of this area while on the water. Bilge's have drain plugs on the back of the boat for when you take it out of the water to fully drain it.
Croatia Boat Show was created in 1998.
Hi, I have several New canisters for Sparton horns. Give me a call at 775-575-0846. Regards, Gary
Insert the drain plug.
Insert the drain plug.