4.2L, 4.6L, 5.4L and 6.8L Engines 1. Disconnect the negative battery cable. 2. Remove the vacuum hose from the EGR valve. 3. On the 4.6L engine, remove the nut and brake booster bracket. 4. On the 5.4L engine, remove the DPFE sensor retaining nuts and place the sensor to the side to allow access to the EGR tube. 5. Disconnect the EGR valve-to-exhaust manifold tube from the EGR valve. 6. Remove the EGR valve mounting bolts, then separate the valve from the intake manifold. 7. Remove and discard the old EGR valve gasket, and clean the gasket mating surfaces on the valve and the intake manifold. To Install: 8. Install the EGR valve, along with a new gasket, on the manifold, then install and tighten the mounting bolts. 9. Connect the EGR valve-to-exhaust manifold tube to the valve, then tighten the tube nut to 25-35 lbs. (34-47 Nm). 10. Connect the vacuum hose to the EGR valve. 11. On the 5.7L engine, install the DPFE sensor. 12. On the 4.6L engine install the brake booster bracket and the retaining nut. 13. Connect the negative battery cable.
where is the crank sensor located on a ford e250 1999
The vehicle speed sensor on Ford E250 is located underneath the vehicle on the transmission beneath the intake mainfold.
It is located in the metal line between the condensor and evaporator. Look for a small crimp in the line.
my 99 e250 with 5.4 gas engine has 2 upstream sensors and 1 down stream sensor.
i have 2000 e250 5.4 and get 12 to 14 mpg.
2
Where is the computer located in the 1995 ford e250 4.9l engine
on the throttle body
TPS is always located on the throttle body. Even on vehicles equipped with rheostat throttles.
Schrader valve on fuel rail.
In the gas tank.
The 2000 Ford E250 didn't come with a cabin filter.