0
Where is the electronic control module located on a 1993 buick skylark custom with a 3.3 engine?
Wiki User
∙ 12y ago
I am no expert but I believe you will find the ECM on the front left side of the engine, in front of the alternator. The ignition coil sits on top of it. Can't miss it all the spark plug wires run to it and its labeled 1-4,2-5,3-6. It shoule be like 6 bolts to get the coils off and it is right under there.
Wiki User
∙ 12y ago
Anonymous
Add your answer:
Earn +20 pts
Where is the transmission solenoid located on a 1995 Buick skylark custom?
Where is the transmission solenoid located on a 1995 buick skylark custom?
Where is the fuel pump of a Buick Skylark custom located?
Gas tank...
Where is the horn located in a 1993 Buick Skylark custom?
on the steering wheel
Will front fenders from a 1971 Buick Skylark Custom fit a 1972 Buick Skylark?
will the fenders from a 1971 Buick Skylark Custom fit a 1972 Buick Skylark?
Will the front fenders of a 1971 Buick Skylark Custom fit a 1972 Buick Skylark?
yes it will, i have a 1971 skylark with a 72' fender on it.
Where is the starter located at Buick skylark 97' custom?
its a round cylinder ( on under belly ) about a foot or two back from the middle front of your car.
Where is the air cabin filter located on a 1997 buick skylark custom 3.1?
Try a GM dealer's service center or parts department. They have diagrams on their computers.
Where can I buy custom Electronic Signs?
You can buy custom Electronic signs online. One such sites I found that sells custom electronic signs is http://www.husksigns.com/.
Where is the rev limiter on a 1994 skylark custom 23?
it's built into the ecm...
Where is the fuel filter on a buick skylark custom 350 2bbl?
It should be attached to the carburetor.
How do you adjust the passenger side mirror on a 1993 buick skylark custom?
Unfortunately only the drivers side has an interior control joystick. The right side is manual and must be adjusted the old fashioned way.
How much does an exhaust for a Buick skylark cost?
We just replaced our entire exhaust system in a 97 skylark custom 4 cylinder 2.4. It cost us almost $700.
