0
Where is the engine block coolant drain plug located on a 1989 Honda Accord EX?
Wiki User
∙ 16y ago
The 2002 Accord has two plugs and both are on the back above the oil filter. Once is a 17mm or 19mm and the other is an 8mm hex. I was not able to break mine loose at 30K or 120K, only 60K and 90K miles. I gave up and asked the dealer that my dealer said not to worry about it that they only drain the radiator if the coolant looks good. Its when the coolant is bad that you need to drain the other gallon. They said just to drain the raidiator and lower hose and fill with HG pre-mix. It cost about $25/Gal.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where is the coolant drain plug on the engine block of a 2003 Honda Accord ex?
where is the coolant drain plug on the engine block of Honda ACCORD 2.4 2006
Where is the coolant located on a 92 Honda Accord?
In the radiator, coolant recover tank, heater core, and inside the engine water jacket.
Where is the coolant temperature sensor tw located on a 1988 Honda Accord 4-cylinder fuel injected with a manual trans located?
The 1988 Honda Accord coolant temperature sensor can be found on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.
Where is the water temp sensor on a 1998 Honda accord 4 cylinder located?
The coolant temperature sensor on a 1998 Honda Accord is located next to the thermostat housing. The sensor has a blue clip located on the right side of the engine compartment.
Where is a coolant temperature sending unit on a Honda Accord?
On a Honda Accord the coolant temperature sending unit is on the passenger side of the upper engine. It is next to the cylinder head.
Freeze plug locations on 93 Honda Accord?
Freeze plugs on a 93 Honda Accord are located along the front and sides of the engine block. They are designed to prevent the engine from being cracked in the event the coolant completely freezes.
A engine diagram for a 1991 2.2 Honda Accord for the coolant hoses?
A Ignition coil diagram for 1991 2.2 Honda accord
Where is the carburetor located on a 1996 Honda Accord?
The 1996 Honda Accord engine is fuel injected and has no carburetor.
How do you flush the engine on a 1997 Honda Accord?
Do you mean flush the oil (not recommended) or flush the coolant?
What does service B5 mean on Honda Accord?
B = Change engine oil and filter.5 = Change engine coolant.
Where is o2 sensor located on 89 Honda Accord lxi?
The Oxygen sensor of a 89 honda accord lxi fuel injection 2.0 valve engine is located in front of the engine on the manifold .
Where is the control sensor located on a 1992 Honda accord?
they are located near the front engine
