Usually looking at the vehicle passenger side running up from right rear freeze plug up to inner fender
The oil pressure switch on a 1998 Chevy Blazer is on the side of the engine block. It is located above the oil filter.
I need diagram for 1998 chevy blazer fuse panel
Unbolt it.
1998 chevy blazer wont start good spark and good fuel presure
HOW TO GET A PULLEY OFF A 1998 CHEVY BLAZER
The transmission dipstick on a 1998 Blazer should be located at the rear of the engine. It should not be near the oil dipstick.
Engine block heaters were optional.
There would be block drains located on each side of the block very close to the engine mounts.
The ERG valve is located on the front of the engine on a 1998 Chevy Blazer V6 4.3L. It is near the top bolted to the intake manifold.
The 1998 Chevy S 10 Blazer 4.3 liter engine fuel pressure regulator will be on top of the engine. The fuel pressure regulator will be attached to the injector fuel pump.
2.8 & 4.3 V6. You can also install a small block Chevy V8.
You have to pull tranny. it is sandwiched between that & block, but pretty straight forward.
Will a 2000 blazer transmission fit a 1998 s 10 chevy 4x4 truck
YES they are the same.
200
Yes they are the same block and heads you might have to swap intakes though
The fuel gauge fuse on 1998 Chevy blazer is located in the front of the blazer. It is on the driver side next to the hook latch.
Yes.
NO it will not. They are complete DIFFERENT designs. Will NOT interchange.
I know of only one in the waterpump.
Yes, they both had the same transmission options.
== ==
The oil cap on a 1998 Chevy Blazer is located on the passenger side of the motor. It is just to the left of the manifold cover.
The fuse box for the fuel gauge on 1998 Chevy blazer is located on the driver side. It is near the hook latch.
Yes it will fit right in there and hook right up.