answersLogoWhite

0

Where is the engine control module on 89 ford f-150 302?

Updated: 8/20/2019
User Avatar

Wiki User

10y ago

Best Answer

wiring diagram

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the engine control module on 89 ford f-150 302?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1995 ford f150 4.9 y Control Module - Ignition?

The ignition control module for a 1995 ford f150 is an important part of the drive train. If the module is failing then the engine will run erratically or not start at all.


What is a ford f150 pcm power control relay?

The power control module (PCM) is the brain of the vehicles engine functions. The relay is a module as part of its power supply circuit.


Location of abs module 1998 ford f150?

The 1998 Ford F1 50 pickup truck ABS module is mounted to the firewall in the engine compartment. The module will be on the passenger side of the firewall.


Where is the ignition control module located on a 95 ford f150 4x4 supercab 5.8 liter?

On the distributor


Where is the body control module on a 2000 Ford Taurus - Mercury Sable?

The 2000 Ford Taurus body control module is located on the firewall in the engine compartment. The module will be on the passenger side, near the bottom, of the firewall.


Where is the wiper control module on a 1993 ford f150?

behind the passanger glove box on the right side. its a small black box.


Where is the airbag module located on a 1997 Ford f150?

The airbag module for the 1997 Ford F150 is located in the passenger side kick panel below the dash. It is silver and black in coloring.


Where is the wiper control module for a 2001 E-450 V10?

The 2001 Ford E4 50 wiper control module can be found on the firewall in the engine compartment. The wiper control module will be in the center of the firewall.


What sensor regulates the air and gasoline Flow on a 1995 Ford f150?

The oxygen sensor in the exhaust ( 2 on a 1995 V8 engine ) is used to send a signal to the powertrain control module to adjust the air / fuel ratio


Where is the intake manifold runner control on a 2002 ford f150 4.2L engine?

The intake runner control is in he intake manifold. It consists of a shaft and 3 butterfly valves for each cylinder bank. The opening of these valves are controlled by an electronic module located on the back of the engine behind the intake manifold ducting on top of the engine. Each set of butterfly valves are connected to the module by a link. When the computer notifies the module to open the butterfly valves, it rotates a small motor in the module, moves the links and opens the butterfly valves. The module is very difficult to get to and you must remove the top ducting to see the links and the butterfly valves


Does check engine light come on with a bad u-joint on a ford f150?

No - check engine light is related to emission control system


Where is the ignition module located on a 1987 Ford F150?

under the dist. cap