It is on the drivers side on the bottom corner facing the engine. It is small and difficult to find. I used a mirror to find it. It has two ears to twist but forget that. If you look at it with a mirror, you will find it it will accept a 3/4" inch socket for a 3/8" ratchet 1/2" rachet might work. Mine is draining very slowly as I type this. Stupid GM engineers. Leon
There are several drain plugs on that vehicle, radiator (coolant), block (coolant), engine oil, trans oil, etc. There are usually located at the lowest point of that particular system.
Dsconnect the rubber hose at the bottom.
its at the bac of the engine under the cooler cables
The radiator on a 98 Buick Century is flushed by turning the petcock to drain the coolant. Water is then flushed through the system until all contaminants are removed.
The flush valve for the radiator on a 1999 Buick Century is located on the bottom of the radiator near the vehicle's frame. When it is loosened, the coolant will slowly drain from the vehicle.
Is there a drain plug on a 2005 Buick century
You drain coolant from the radiator. but according to the book ther are two plugs on the engine block that need to drain the coolant from.
Answering "Where is engine coolant drain plug for a 1.8 Nissan sentra engine?"
To actually "flush" the coolant in this vehicle you will need a flush machine. To do that we did at the dealership, drain the radiator (you need a 1/4 inch ratchet and 1 inch extension) then use a vacuum fill too to fill with new coolant.
Place something to catch the engine coolant beneath your 1990 Chevy Corsica radiator. Remove the radiator drain plug with a 9/16 ratchet. The engine coolant will drain out.
Should be a plastic key shaped thing. bottom of tank, corner, engine side.
The engine coolant drain plug on a Mitsubishi V6 engine is located on the bottom of the radiator. This allows for coolant to be quickly and easily drained.
The 2002 Tacoma engine block will have two coolant drain plugs on each side of the block. The coolant drain plugs will be near the front and the rear of the engine block.
The 1994 Lincoln Town Car 4.6 liter engine coolant drain plugs can be found on each side of the engine block. There will be a total of four engine coolant drain plugs.
The coolant drain plug is located on bottom corner of radiator facing engine.
That is always a messy job at best. If you don't drain it you are going to spill radiator fluid all over your engine when you take a hose off. It is best to drain it into a pan and then add new fluid when you are all done. You may want to flush the engine and radiator out with a cleaning agent while you are at it.
Assuming there is coolant in the engine the most likely cause is a build up of sediment behind the coolant drain or in the coolant drain tap itself.
The engine coolant drain plug, on a 1998 Ford expedition, is located on the bottom of the radiator. The drain plug will come out by turning to the left.
where is the coolant drain plug on the engine block of Honda ACCORD 2.4 2006
Sometimes they use that threaded drain plug location to attach a knock sensor. So if you see a knock sensor threaded into the side of the block that may be where the coolant drain is located.
Most vehicles have a drain on both.
IF YOU ARE TALKING ABOUT THE COOLANT DRAIN ON THE ENGINE BLOCK YOU REMOVE THE KNOCK SENSOR ON THE LOWER SIDE OF THE ENGINE, IT HAS A WIRE ON IT . IT IS BACK OF THE MOTOR MOUNT. WHEN YOU FILL THE ENGINE BACK UP WITH COOLANT BE SURE TO GET THE AIR OUT (94 ON)THERE IS A SMALL SCREW ON THE TOP OF THE ENGINE JUST BEFORE THE THE TOP HOSE GOES INTO THE BLOCK, JUST LOOSEN IT TILL THE AIR IS ALL OUT.
Open the drain valve on the side of the engine block.
The coolant drain plug on a Nissan Micra engine block is on the upper part of the block. It is under the intake manifold.
there is a drain plug/petcock in one of the corners on the engine side of the radiator. you just have to open that and the coolant will drain out. remember coolant is hazardous to pets as well as the environment.