It is located above the glove box. Remove the box and look up and to the left just under the dash. It is mounted to the main cross member and is very hard to change out unless you remove the dash, this is due to the mounting bolt placements.
The 2003 Lincoln Town Car factory amplifier is located in the trunk. The factory installed amplifier will be on the dividing wall between the back seat and the trunk.
There where no factory installed grease zerks.There where no factory installed grease zerks.
No.
The factory scan tool is required.The factory scan tool is required.
No
About 250 horsepower
They sell all the factory manuals at: www.TheViperStore.com
One from the factory.
Speaker fuse or a bad wire. The actual problem is a faulty factory amplifier. We had the same problem, at first we would just turn the radio off for a short period of time and usually this would work. I have since replace the factory amp. and no longer have the problem. The factory amp is located in the cargo area on the passenger side. You will have the remove the side panel on the right side, and to do this the seat belt hold down will have to be removed. Good luck
If the radio fails and a component shorts out, the fuse is supposed to prevent the vehicle wiring from catching fire and burning up the vehicle.
You should be able to find it under the front passenger seat.
there should be two holes, vertically, on each side of the radio, you can make a tool out of a coat hanger to stick into each side, when you have placed your homemade radio tool into the holes, simultaneously, you should be able to pull the factory radio out