it should be in the shifter.
It is not recommended to wire a cooling fan directly to a light relay as the fan may draw more current than the relay is rated for. It is safer and more reliable to use a dedicated fan relay and wiring harness designed for the specific application.
Need more info to give you the most usefull answer. However, generically speaking, sounds like what you need is a 120v relay. Put the relay output contacts in series with the fan (aka the load) then wire the relay coil in parallel to the light bulb power. This will make the load come on when the light is powered on. Tip, if the fan is driven by an induction motor (most are, if it has brushes it is NOT an induction motor) then your speed controller will have to be the kind for an inductive load ( NOT the kind for a resistive load, like a lightbulb ). Good luck.AnswerA solid state relay, or SSR should do it for you. SSRs take a broad range of input voltage as you require, and have snubbers to allow them to switch inductive loads such as the fan.
Next to the battery, to the left, is the fan control unity. It is a big black box that holds several smaller relays. The fan conrol switch is in a different location and you may be confusing this two.
A fan interlock relay can be used to prevent the electric heater from being energized when the fan is not running. This relay will only allow power to the heater when the fan is operating, ensuring that the heater cannot operate independently.
To change out a fan relay for a 1993 Mercury Topaz, locate the relay, typically found in the engine compartment near the radiator. Disconnect the negative battery cable, remove the old relay, and insert the new one in its place. Reconnect the negative battery cable and test the fan to ensure the new relay is functioning correctly.
Yes it is electric and no it's not supposed to run all the time, have the fan relay switch checked out, it probably needs replaced.
location of the fan relay switch on a 1989 Chevy Corsica
The cooling fan relay switch can be located on the back of the cooling fan motor. The relay switch should be labeled as such.
The 1996 Oldsmobile fan relay switch can be found in the fuse box. The fan relay switch will be in the third column, second from the top.
where is cooling fan relay switch located on 2000 s-type jaguar
The 1996 Mercury cooling fan relay switch is on the back of the cooling fan motor. The relay switch should be labeled as such.
The heater fan relay switch can be found on the firewall in the engine compartment. The relay switch will be on the passenger side of the firewall.
Check your thermostat switch.
The 1986 Pontiac Firebird fan relay switch can be found on the back of the fan motor. The relay switch is connected to the fan motor by two retaining screws.
The cooling fan relay switch can be found on the inside front quarter panel. The relay switch will be on the drivers side quarter panel.
The 1997 Acura Integra fan relay switch is located inside of the fuse box. The fan relay switch will be in the third column, second from the top.
The 1994 Chevy Corsica fan relay switch is located beneath the passenger side dashboard. The fan relay switch should be labeled as such.