Saturn's did not have a place on the radiator to fill the coolant; you'll need to look for the coolant reservoir, which was typically somewhere in front of the passenger. Note the fill level marks on the side of the reservoir; do not exceed the appropriate mark. (one for when the engine is hot, the other for when the engine is cool.) and do not open the reservoir when the engine is hot.
You fill it though the resivoir cap
where do you fill radiator on 2001 ford taurus
A fill spout on a Chevy Suburban is used as the inlet for filling an FIBC.
I, too, am the owner of a 1995 Saturn SC1 and had the same question. The answer is no, not without unhooking the radiator. Sounds stupid to me, but that's the way it is!
on my 1992 lumina z34 its about 5 inches from top on passenger side of car directly below radiator fill spout
If Im not mistaken, the Pressure cap for a Saturn is the twist on cap on top of the coolant resovoir, if the cap say under pressure then that is it and to add coolant to radiator you fill it thru the res.
It will draw it in from the overflow tank when it is needed. Fill that up to the proper line.
there is a drain cock located on the radiator, it is on the bottom passenger side facing inside the engine bay. looking under the car below the radiator you will see holes on each side of the car (where the radiator sits) that is where the coolant will come out (pass. side) after draining you will need to get the air out of the system. on the top of the motor directly behind the water pump housing there is a spout with a 10 mm nut, loosen this and fill coolant in reservoir until water comes out of the spout. close spout and fill to line in reservoir. do this with the vehicle off so the water pump isn't on and the car doesn't overheat. good luck..
drain and pull the old radiator out, slide the new one in and fill it up
Take radiator cap off, fill radiator with coolant, put cap back on!
Fill Spout. When filling your tank with gas, you will need to open your gas tank, unscrew and remove your gas cap, remove the nozzle from the pump and put it in the fill spout.
There is not one. You just have to loosen the bottom radiator hose and open the fill cap on the antifreeze reservoir when the vehicle is cool.